Sound Technology AKG C519M Wired Clip On Saxophone Microphone

A solid and great sounding Clip-on Saxophone Microphone

– Miniature condenser clip-on microphone for saxophone

– Miniature gooseneck for accurate microphone alignment

– Detachable microphone cable

– Transducer shock mount for high mechanical-noise rejection

– The C 519 clips onto the bell of a trumpet, saxophone, trombone, tuba, or any other wind instrument (e.g. didgeridoo). Room to move for the wind section at last! Its tight cardioid polar pattern makes the C 519 an ideal tool for use near monitor wedges, and its flat frequency response delivers a natural, powerful, and clear sound. 

Phantom Power

This microphone requires ‘phantom power’ to function. Though this is standard for the vast majority of modern amps and sound desks it is advisable to check before ordering 

Specification

Polar pattern: cardioid

Frequency range: 60 Hz to 20 kHz

Sensitivity: 5 mV/Pa (-46 dBV)

Max. SPL: 130/132 dB SPL (for 1 %/3 % THD)

Equivalent noise level: 31 dB(A)

Signal/noise ratio: (A-weighted) 63 dB

Impedance: = 200 ohms

Recommended load impedance: >= 2000 ohms

Powering: = 2 mA

Power requirement: B 29 L battery power supply, MPA V L phantom adapter, AKG WMS bodypack transmitters

Connector: 3-pin mini XLR

Cable: 1.5 m (5 ft.)

Finish matte black

Dimensions Length: 213 mm (8.4 in.) (microphone only); max. width: 47 mm (1.9 in.)

Net weight C 519 M: 195 g (6.9 oz.)

C 519 ML: 85 g (3 oz.) (microphone and cable)